Hardware
Flywheel Shims
$1.80 USD
Flywheel Shims used to set the end play. We offer individual shims as well as a variety pack to help you set the endplay on your engine. Use the drop...
Brass 8mm x 1.25 Nuts, 11mm head SET OF 8
$7.50 USD
These nuts are a little longer than a standard steel nut, but only require an 11mm wrench to install instead of a 13mm. Great for tight/hard to reach areas. We...
SS EPDM Loop Clamp
$2.50 USD
Stainless Steel loop clamp with EPDM rubber cushion. Properly sized for T series tubing. sold each. Measures 19mm or 3/4"
Stock Style 8mm Oil Pump Cover - DANSK
$12.00 USD
Stock Style 8mm oil pump cover. Heavy Duty, thick, Zinc plated and ground flat gasket surface. Heavy Duty! works and looks great. OEM # 311 115 141C
HD Stock Oil Drain Plate - Screen Cover - With Hole
$8.00 USD
Built to stock specs. Nice and thick, Heavy Duty! Zinc plated for years of worry free performance, great candidate to paint or powdercoat to match your engine, or run it...
Drain Plate Drain Plug - Stock
$4.50 USD
Stock Steel Drain plug for drain plate. 21mm head.
Distributor Drive Washer - set of 3
$2.50 USD
Washers for the distributor drive gear. Install these on the Distributor drive to keep it from eating the case. 3 is the usual number needed but the play needs to...
Type 3 Block Off Plate
$5.00 USD
– Sold OutThick Steel Block off plate for Universal and Type 3 cases lower oil fill flange. Surface ground for a good seal. Includes gasket.
Cam Plug - Metal
$3.00 USD
metal cam plug for type 1 engines cases with groove.
Crankshaft Woodruff Key (Large one)
$2.50 USD
Crankshaft Large Woodruff Key for timing and distributor gears. 111105213
Crank Pulley Woodruff Key (small one)
$2.50 USD
small woodruff key for pulley on crankshaft113105249
Case Stud Sealing O-rings - Set of 6
$4.00 USD
Large O-rings for the six case half studs. Always use new O-rings when you split the case.
Case Bypass Plug
$4.00 USD
Oil relief / Oil bypass plug. Hardened, Allen Head style, with sealing washer. Simply the best plugs, why use anything else? the 10mm Allen head makes it a breeze to...
WIDE muffler air pod clamp
$2.50 USD
These muffler air pod clamps are 1.5" wide, so that you can install them without going completely insane trying to seal the muffler pods to the heater boxes with the...
Engine Nut and Washer Kit - Hardened
$20.00 USD
Our favorite engine nut kit. 103 pieces, hardened, for 8mm or 10mm head studs, choose in drop down menu. These are the nuts and washers we use on our engines. ...